Toyota Tundra Front Receiver Hitch Installation And Review Videos

Front Mount Trailer Hitch Installation - 2001 Toyota Tundra- Video

Today on our 2001 Toyota Tundra well be installing the Curt Front Mounted Hitch, part number 31180. This is what our hitch will look like once its installed. Next well go ahead and give you a couple measurements to assist you with selecting accessories for your new hitch. From the center of the hitch pin hole to the front most edge of the bumper is two and three quarter inches. From the top of the receiver tube to the ground is 14 inches. First, before we can install the hitch, well need to remove the front tow hooks. more

11/5/2012 1:24:18 PM

Front Mount Trailer Hitch Installation - 2005 Toyota Tundra- Video

Today we are going to install part number 65031 from Draw-Tite, and we are going to install this on a 2005 Toyota Tundra pickup. To begin our install, let us take a few pieces off the vehicle. First off, this tow hook right here has to come off it will stay off. This skid plate right here, that will have to come off and stay off. And then this hook over here, this loop or tie-down has to come off, also. This bolt here and here and there are two back here that come out and allow the shield to come down. Next we will install the hitch on existing weld nuts. It is a good idea to have an extra set of hands because it is kind of heavy and kind of wide. Once we have the hitch installed by the factory bolts I am sorry, with the factory holes then we use the hitch as a template to drill out the last two remaining holes. All right, what we will do from here on out is, we will go ahead and snug the bolts down, lock the hitch into position, and we will start our drilling. The hitch will mark where our holes are going to be drilled at. Again, we will use it for a template. We will start off with a 1/4-inch drill bit to make a pilot hole, and then we will follow it up with a 1/2-inch bit. And this is the other one right here. more

1/2/2009 3:24:02 AM